Sanyo PM8200 PM-8200 Faceplate Installation
|
Please note: Faceplate installation should be performed carefully. These installations instructions are intended to be a guide instead of a complete set of instructions. These instructions assume you or your designated
installer has a basic knowledge and experience in taking cell phones apart. DayDeal, Inc. & DayDeal.com is not responsible for damage to the phone or phone parts during or after installation. When performing installation,
be careful not to lose any parts and note placement of parts prior to removal. |
|
| 1. |  Remove the 4 screws (indicated with red circles) with a 3-Point Screwdriver. |
| 2. |  Separate the front and back housings of the phone. You will need to use the Pry Tool to release the tabs along the sides of the phone. |
| 3. |  With a small flat-head screwdriver, push the left hinge spring out. |
 |
|
| 4. |  Remove the sticker/plugs and the 4 screws (indicated with red circles) with a 3-Point Screwdriver. |
| 5. |  Lift up the faceplate. You may need to use your Pry Tool to separate the faceplate from the phone. |
| 6. |  Remove the center hinge cover. |
| 7. |  With a small flat-head screwdriver, push the right hinge spring out. |
 |
|
| 8. |  Separate the faceplate from the phone. |
| 9. |  Remove the loud speaker with your Philips head screwdriver and transfer that to the new faceplate. |
| 10. |  Should look like this. |
| 11. |  Replace the center hinge cover to the phone. |
| 12. |  Reattach faceplate to the phone by placing it in place. |
| 13. |  Reattach the two hinge springs. |
| 14. |  Reattach the front and back housings of the phone. |
| 15. |  Replace the 4 screws. |
| 16. |  Replace the 4 screws around the inside LCD screen. |
| 17. |  Installation is complete. |
- Free Shipping on cell phone accessories
- Unbeatable product selection
- Outstanding customer service
- No hassle returns
- Up-to-date shipping info
- Safe & secure online ordering
