Sanyo SCP-200 & VI-2300 Faceplate Installation Instructions

Faceplates for the Sanyo SCP-200 & Sanyo VI-2300 are almost the same. The only difference is the VI-2300 has an external display; however, faceplate installation is exactly the same. The installation procedure is relatively easy. Most users will be able to perform this installation. Please note: Sanyo VI-2300 & SCP-200 Faceplate installation should be performed carefully. These installations instructions are intended to be a guide instead of a complete set of instructions. These instructions assume you or your designated installer has a basic knowledge and experience in taking things apart. DayDeal, Inc. & DayDeal.com is not responsible for damage to the phone or phone parts during or after installation. When performing installation, be careful not to lose any parts and note placement of parts prior to removal. Please read through entire instructions before proceeding. Also read each step before proceeding as each step contains notes and tips on smooth and easy installation. You'll need a 3-Point screwdriver. Sanyo SCP-200 & Sanyo VI-2300 Faceplate installation pictures provided by Valor.
1.	With the phone turned off and battery removed, begin by removing the 4 screw covers and screws with your 3-point screwdriver.

2.	Next, remove the hinge cover on both sides of the phone. You can use a pair of tweezers as shown or a pin can also do the job. Under both hinge covers, gently pry out the hinge spring with a flat head screwdriver. Then remove the original faceplate by gently prying along the edges of the faceplate. You can use a flat head screwdriver as shown or use our Pry Tool to prevent scratching the faceplate or phone.

3.	With the faceplate removed, take off the loud speaker be removing the two screws that secures it.

4.	This is what your phone should look like (Sanyo VI-2300 shown, Sanyo SCP-200 is similar).

5.	We're going to be installing a pink faceplate.

6.	Attach the loud speaker to the new faceplate. Please do not over-tighten the screws.

7.	Prepare to reattach new faceplate to phone.

8.	Reattach new faceplate by inserting the faceplate at the top of the phone. When the faceplate is properly aligned, snap the faceplate to the phone along the edges of the faceplate.

9.	Re-insert the two hinge springs and hinge covers.

10.	Replace the screws. Please do not over-tighten the screws. Also replace the screw covers.

11.	Replace battery and battery cover.

12.	Faceplate installation is now completed. (Sanyo VI-2300 shown, Sanyo SCP-200 shown below).

13.	This is what the Sanyo SCP-200 looks like with a blue faceplate and battery cover.