Nextel i265 i275 Faceplate Installation

Faceplates for Nextel i265 and i275 are the same and installation is relatively easy. Most users will be able to perform this installation. Please note: Nextel i265 & i275 Faceplate installation should be performed carefully. These installations instructions are intended to be a guide instead of a complete set of instructions. These instructions assume you or your designated installer has a basic knowledge and experience in taking cell phones apart. DayDeal, Inc. & DayDeal.com is not responsible for damage to the phone or phone parts during or after installation. When performing installation, be careful not to lose any parts and note placement of parts prior to removal. Please read through entire instructions before proceeding. Also read each step before proceeding as each step contains notes and tips on smooth and easy installation. You'll need a small Torx #6 screwdriver. Nextel i265 & i275 Faceplate installation pictures provided by Valor.
1.	To begin you'll need a Torx # 6 screwdriver. A pair of tweezers and a flat head screwdriver would be helpful as well.

2.	With the phone turned off, remove the battery cover and the battery.

3.	Remove the antenna by unscrewing it. Remove the screws as indicated.


4.	Remove the back housing of the phone by separating it for the front.

5.	From the front housing of the phone, gently lift out the main circuit board. Do not separate it from the phone yet.

6.	At the ribbon cable connector, lift up the trap door which locks the ribbon cable in place. After you lift the trap door, ribbon cable can be disconnected from its connector.

7.	This is what you should have now.


8.	Remove the LCD screen by release it from its tabs along the two sides of the LCD screen. We recommend you not touch the back side of the LCD screen.

9.	Remove the speaker assembly and the microphone by gently prying if off. Be careful not to damage these parts.

10.	Replace the speaker assembly on to the new faceplate.

11.	Replace the LCD screen on to the new faceplate by gently snapping in place. Make sure the tabs lock in place and that the LCD screen is properly aligned. Again, please do not touch the back side of the LCD screen.

12.	Replace the microphone and the keypad on to the new faceplate.

13.	Reconnect the ribbon cable to the main circuit board by gently sliding it into its connector. After ribbon cable is properly aligned and inserted, close the trap door to lock the ribbon cable in place. Be careful not to damage ribbon cable.

14.	Reattach back side of the phone to the front side of the phone.

15.	Replace the screws and the antenna.

16.	Replace the battery and new battery cover.

17.	Your faceplate installation is now complete.